background image

Operating Instructions  

ModMAX Series

MaxLite LED ModMAX Fixtures

Page: 1

REV: 1/11/17

®

• To reduce the risk of death, personal injury or property damage from fire, 

electric shock, falling parts, cuts/abrasions, and other hazards read all 

warnings and instructions included with and on the fixture box and all 

fixture labels.

• Before installing, servicing, or performing routine maintenance upon 

this equipment, follow these general precautions.

• Commercial installation, service and maintenance of luminaires 

should be performed by a qualified licensed electrician.

• For Residential installation: If you are unsure about the installation 

or maintenance of the luminaires, consult a qualified licensed electrician 

and check your local electrical code.

• DO NOT INSTALL DAMAGED PRODUCT!

• This fixture is intended to be connected to a properly installed and 

grounded UL listed junction box.

WARNING:

RISK OF ELECTRICALSHOCK

• Turn off electrical power at fuse or circuit breaker box before wiring fixture 

to the power supply.

• Turn off the power when you perform any maintenance.

• Verify that supply voltage is correct by comparing it with the luminaire label 

information.

• Make all electrical and grounded connections in accordance with the National Electrical 

Code and any applicable local code requirements.

• All wiring connections should be capped with UL approved wire connectors. 

CAUTION: 

RISK OF INJURY

• Wear gloves and safety glasses at all times when removing luminaire from carton, installing, 

servicing or performing maintenance.

• Avoid direct eye exposure to the light source while it is on.

• Account for small parts and destroy packing material, as these may be hazardous to children.

CAUTION: 

RISK OF FIRE

• Keep combustible and other materials that can burn away from luminaire and lamp/lens.

• MIN 90°C SUPPLY CONDUCTORS.

Input Rating: 

120V-277V 50/60Hz

Operating Temperature:

-22°F to 122°F

Wet Location Rated

General Safety Information

Illustrations on the manual are for

installation purposes only. It may not

be identical to the fixture purchased.

© Copyright 2017. MaxLite, Inc. All Rights Reserved.

12 York Ave, West Caldwell, NJ 07006   Tel: 973-244-7300   Fax: 973-244-7333   Email: [email protected]

Summary of Contents for ModMAX 97374










Reviews: