Figure 5. Selecting the MaxQ option from the initial device selection dialog box in MTK2.
Next, configure and open the serial port. Make sure the USB-to-serial adapter is connected; use DS1 to
confirm the adapter is powered and check that the device has enumerated properly (
Devices and Printers
from the
Start
menu) before continuing. From the MTK menu, select
Options
Configure Serial Port
. In
the dialog box (
Figure 6
), select the VCP that the USB-to-serial adapter is connected to (choose from the
drop-down list, or enter it directly in the
Port
field) and click
Ok
.
Figure 6. Configuring the serial port to load code in MTK2.
Now, connect the USB-to-serial adapter to the DS8005 evaluation kit board with the provided 10-pin ribbon
cable. Use the red indicator to make sure pin 1 of the adapter’s JTAG header is connected to the TCK pin of
the JTAG header on the DS8005 (
Figure 7
). Ensure that the jumper settings on the board are on their default
settings, as specified in the
Setting Up the DS8005 Evaluation Kit
section. Then from the MTK menu again,
select
Target
Connect to Loader
to connect to the MAXQ622’s loader. MTK should output a message
showing that it was successful in communicating with the MaxQ Bootloader (
Figure 8
).
Page 8 of 22