
43
Maxim Integrated
Evaluates: DS34S132
DS34S132 Evaluation Kit
Table 4-7. CESoPSN Bundle Parameter Descriptions
PARAMETER
DESCRIPTION
POSSIBLE VALUES
Bundle Type
Select the bundle type.
HDLC
SAToP
CES
Assign this
Bundle to
PCM port
Number of the TDM port to which the bundle is assigned.
1–32
Timeslot
Assignment
[1 - 24]
Assigns time slots to the previously selected bundle, for
example, 1–5, 7, 8, 9, 12–15.
T1:
1–24
E1:
1–31
TX Bundle
Destination
Destination of the Tx data flow toward the ETH port.
Note:
The Tx bundle destination cannot be changed after the
bundle configuration has been saved.
Ethernet:
TDM to Ethernet
CPU:
TDM to CPU
Cross connect:
TDM to TDM (not supported
yet)
Default: Ethernet
RX Bundle
Destination
Destination of the Rx data flow from the ETH port
Note:
The Rx bundle destination cannot be changed after the
bundle configuration has been saved.
CPU:
CPU
PCM:
TDM (PCM bus)
Discard:
Discarded
Default: PCM
TX Bundle
Number
[0 - 65535]
Number of the desired Tx bundle.
Default: 2
RX Bundle
Number
[0 - 65535]
Number of the desired Rx bundle.
Note:
Must be unique for each bundle ID.
Default: 2
Source IP
Address
Assign the bundle one of the source IP addresses configured
in the
General Configuration
menu.
IP 1, IP 2
Default: IP 1
Destination
Main MAC
Address
MAC address of destination device.
Note:
If the destination Main MAC address is different from
the default value, the MAC is not learned in the ARP process.
Default: 0020D224A346
Destination IP
Address
IP address of the destination device
10.10.10.5
Next Hop IP
The Next Hop parameter should be used when the
Destination IP Address is not in the device subnet. In such
cases the Ethernet packet is sent to the Next Hop IP. The
default value of the Next Hop field is the default gateway.
Note:
The Next Hop must be in the same subset as the
Source IP address of the bundle ID.
0.0.0.0
IP ToS
[0 - 255]
Sets the IP ToS field in the IP ETH packets leaving the EV kit.
ToS setting defines the whole byte, since different vendors
could use different bits to tag packets for traffic prioritization.
The ToS assignment applies to all ETH packets leaving the
EV kit for this bundle.
Note:
This parameter is displayed only if PSN Type is set to IP.
0–255
Default: 0