Maxi Comet Executive Exec-56-G, Instruction Manual, Page: 137 / 244

Comet Executive Gas Repair
7-29
7.6 Burner System
Individual components of the burner system
may wear during normal use and may need
occasional repair, inspection, or adjustment.
If the burner is experiencing problems,
first inspect and clean the spark plug and pilot
assembly. For more information, refer to Check
and Clean Pilot Assembly on page 4-18 .
If the spark plug does not appear to be the
problem, the following procedures also may be
used to resolve the problem:
• Burner Removal/Replacement
• Burner Tip Maintenance
• Temperature Sensor Contact Shoe
Replacement
• Temperature Control or High
Temperature Limit Control Replacement
Burner Removal/Replacement
When the ironing cylinder does not heat up
properly, this may be caused by a lint buildup. The
entire gas burner must be removed to completely
clean the gas burner system.
NOTE: Before beginning this
procedure, refer to Heating
System on page 6-12
, for other
possible causes/solutions.
Make sure the unit is completely COOL before
beginning this procedure.
NOTE: Ta k e t h e t i m e t o
read through and understand
the entire procedure before
performing this work.
This procedure should be handled
by at least two qualified persons.
Using the “buddy system”
facilitates a quicker procedure
and decreases the risk of
an accident.
Required Tools
Allen wrench: 5/32”
C-clamp: large
Clean cloth
Compressed air
Gloves
Pencil/marker
Pipe thread compound/Teflon
tape
Pipe wrench
Wrenches:
7/16”
9/16” (2)
TOC INDEX