Maxcess MAGPOWR DLCA NET-S1, User Manual

Page: 44 / 67

COMMUNICATIONS INTERFACE
www.maxcessintl.com DLCA NET-S1 MI 850A374 1 A Page 44 of 67
8.6.1 Command request
Commands start at 0x0 and continue to 0x1FF.
Parameters start at 0x200 and continue to 0x3FF.
For parameters, add 0x1000 for a Write and 0x0000 for a Read to
the parameter number.
8.6.2
Command/parameter list
WO = Write Only, RO = Read only, RW = Read and Write
The parameter Class specifies which group this parameter
belongs to in the DLCA NET-S1. The class can be communication
(Comm), parameter (Parm), load cell calibration (LC Cal), or
output calibration (Out Cal). This classification is used when
resetting parameters to defaults with the NV Reset commands.
Data types
int16 = signed 16-bit integer
uint32 = unsigned 32-bit integer
int32 = signed 32-bit integer
float = 32-bit single precision floating point number
Some commands and parameters are not useful for the two
tension zone DLCA NET-S1.
Command/
Parameter Number
Function or Parameter Type Class
Data Type
and R/W
Explanation
Hex Decimal
0x000 0 Idle Function None WO
0x001 1 Zero Calibrate Zone 1 Function None WO See 0
0x002 2 Precision Calibrate Zone 1 Function None WO See 0
0x003 3 Not Available Function None WO
0x004 4 Zero Calibrate Zone 2 Function None WO See 0
0x005 5 Precision Calibrate Zone 2 Function None WO See 0
0x006 6 Not Available Function None WO
0x007 7 Cal Output 0, 10V, 0% Function None WO – int16 See 8.7.4
0x008 8 Cal Output 0, 10V, 100% Function None WO – int16 See 8.7.4
0x009 9 Cal Output 0, 20mA, 0% Function None WO – int16 See 8.7.4
0x00A 10 Cal Output 0, 20mA, 100% Function None WO – int16 See 8.7.4
0x00B 11 Cal Output 1, 10V, 0% Function None WO – int16 See 8.7.4
0x00C 12 Cal Output 1, 10V, 100% Function None WO – int16 See 8.7.4
0x00D 13 Cal Output 1, 20mA, 0% Function None WO – int16 See 8.7.4
0x00E 14 Cal Output 1, 20mA, 100% Function None WO – int16 See 8.7.4
Command
Read or write