CONTROLLER MENUS: 1Y.3 JOB SETTINGS
7 - 4
D-MAXE with OI-B/OI-N
www.maxcessintl.com
MI 2-296 1 D
1y.3 Job Settings
This section is a description of menus that are used to set up
the parameters of a job. A similar set of parameters is available
for each job in the system. The settings of this job apply to
"Automatic" mode.
However, the number of available parameters that can be set for
a job depends on customer-specific programming of the D-
MAXE system.
Each job is identified by a capital letter in the status line
"Manual" mode:
– All parameters are available.
– The identification of the job appears again in lower menu
levels. The two identifications do not match. However, you
can press the F4 key to show the settings of other jobs and to
change them (in the example y = A and z = E).
To simplify menu identifications in the explanations below,
we assume the two jobs are identical (y = z).
"Automatic" mode:
– Only selected parameters are available.
– The identification of the job appears again in lower menu
levels in "Automatic“ mode. The two identifications match
and cannot be changed at this point.
"Servo-Center" mode:
– These parameters cannot be set.
