12
6. MAINTAIN FOR PERFORMANCE
1
DO NOT FIRE THE NAILER WHEN IT IS EMPTY
2
USE A 3-PIECE AIRSET
Failure to use a 3-piece airset allows the moisture and dirt inside
compressor to pass into the tool directly. This causes rust and
wear, and results in a poor operating performance. The hose
length between airset and tool should be no longer than 5 m since
a longer length results in a reduction in air pressure.
3
USE RECOMMENDED OIL
The velocite or turbine oil should be used to lubricate the tool.
Upon completion of operations, place 2 or 3 drops of oil into the
Air Plug inlet with the jet oiler. (Recommended Oil : ISO VG32)
4
INSPECT AND MAINTAIN DAILY OR BEFORE OPERA-
TION
Disconnect air supply and empty the Magazine when inspect-
ing or maintaining the tool.
(1)
Drain air line filter and compressor
(2)
Keep lubricator filled in air 3-pieces set
(3)
Clean filter element of air 3-pieces set
(4)
Tighten all screws
(5)
Keep Contact Arm moving smoothly
7. STORING
1
When not in use for an extended period, apply a thin coat of
the lubricant to the steel parts to avoid rust.
2
Do not store the tool in a cold weather environment. Keep
the tool in a warm area.
3
When not in use, the tool should be stored in a warm and
dry place. Keep out of reach of children.
4
All quality tools will eventually require servicing or replace-
ment of parts because of wear from the normal use.
8. TROUBLE SHOOTING/REPAIRS
The troubleshooting and/or repairs shall be carried out only by
the MAX CO., LTD. authorised distributors or by other specialists.
WARNING