Page 22 of 54
5100054
BND01O03.docx
WARNING – Falling parts.
Check that all screws are properly tightened:
•
Countersunk screw ISO 10642 M4x6
②
to 2 Nm
•
Allen cylinder screw ISO 4762 M6x10
⑤
to 10 Nm
10.5.
Installation of the Spring Arm
Figure 14 End-Stop between Spring Arm
and Extension Arm
1.
Place the end-stop
②
onto the spring arm
spindle
①
.
•
The single knob must face upwards and to the
rear end of the spring arm as depicted in
Figure 14.
WARNING – Electric Shock
Power cables can be twisted off
without a mounted end-stop!
1.
Pull both latch pins
①
upward and both
securing elements
②
out of the
extension arm, until the latch pins snap
into the securing elements
⑤
.
2.
Insert the spring arm spindle
④
into the
extension arm up to the end-stop
without tilting.
3.
Push both securing elements
②
into the
extension arm until they snap into
place.
•
Both securing elements
②
must
protrude into the groove
③
on the
spring arm spindle
⑤
.
•
The latch pins
①
must audibly click into
place!
WARNING – Falling parts
If the securing elements
②
are not mounted properly
there is a risk of the spring
arm 2 with injector column
and injector dropping and
causing serious injuries
