Matsusada HARS Series, Instruction Manual

Page: 12 / 92

1 Features and Specifications
2
HARS series
1-4 Output Specifications
Model
Rated output
voltage [kV]
Rated output current
[mA]
Rated output
power [W]
HARS-1*500 1 500 500
HARS-1*1000 1 1000 1000
HARS-1*2000 1 2000 2000
HARS-1*3000 1 3000 3000
HARS-1.5*333 1.5 333 500
HARS-1.5*666 1.5 666 1000
HARS-1.5*1333 1.5 1333 2000
HARS-1.5*2000 1.5 2000 3000
HARS-3*166 3 166 500
HARS-3*333 3 333 1000
HARS-3*666 3 666 2000
HARS-3*1000 3 1000 3000
HARS-6*83.3 6 83.3 500
HARS-6*166 6 166 1000
HARS-6*333 6 333 2000
HARS-6*500 6 500 3000
HARS-10*50 10 50 500
HARS-10*100 10 100 1000
HARS-10*200 10 200 2000
HARS-10*300 10 300 3000
HARS-30*16.6 30 16.6 500
HARS-30*33.3 30 33.3 1000
HARS-30*66.6 30 66.6 2000
HARS-30*100 30 100 3000
HARS-60*8.33 60 8.33 500
HARS-60*16.6 60 16.6 1000
HARS-60*33.3 60 33.3 2000
HARS-60*50 60 50 3000
HARS-100*5 100 5 500
HARS-100*10 100 10 1000
HARS-100*20 100 20 2000
HARS-100*30 100 30 3000
HARS-120*4.16 120 4.16 500
HARS-120*8.33 120 8.33 1000
HARS-120*16.6 120 16.6 2000
HARS-120*25 120 25 3000
The output type is described in * with P or N. (P: Posituve polarity output N: Negative polarity output)

The voltage, current, and power that are shown in the table are output to the output
terminals on this product.

Do not touch the output terminals or loads while the product is operating, or immediately
after operation has stopped.

Before touching the output terminals or load, set the output voltage/current to zero and
turn off the OUTPUT switch. Make sure that the values for voltage/current are zero on the
display. Turn off the POWER ON/OFF switch, and turn off the main power supply. Ground
between the output terminals and the GND terminals, and use a voltmeter to confirm that
the voltage value is zero.