24
Matrox Display Wall – User Guide
Installing multiple cards
Your chassis model may support the installation of multiple Matrox cards in your system. For
information on validated platforms, contact your Matrox representative or see the Matrox web site
(
).
Interconnecting multiple cards (Framelock)
Mura MPX Series, C900, and C680 only
– If you have multiple Mura MPX output cards or
multiple C900 or C680 graphics cards installed in your system, you can synchronize the
frame rate of all your outputs by interconnecting your cards with a ribbon cable.
*
Mura MPX Series –
Attach the ribbon cable
to the connector labeled
Out
on one card to
the connector labeled
In
on the next card.
Depending on the length needed, use either
the long or short ribbon cable included with
your product.
Repeat this for every card installed.
C900 and C680 –
You can interconnect either two C900 graphics cards or two C680 graphics
cards.
Attach the ribbon cable to the connector
labeled
GEN0
on one card and to the
connector labeled
GEN0
on the next
graphics card.
WARNING:
To avoid damaging your
cards, always insert your card as straight as
possible into the slot. Don’t rock the card
from side to side. If you meet resistance,
don’t force the card into the slot.
* Matrox C900 and C680 – Ribbon cable sold separately.
Out
In
GEN0
GEN1
Summary of Contents for Mura MPX-4/0
