Matrox Mura D-Series, System Builder'S Manual

Page: 72 / 88

72 Matrox Display Wall – System Builder’s Guide
Supermicro H11SSL-i
Configurations
D-Series based controllers Third-party based controllers
Validated Yes No foreseeable compatibility issues
Maximum number of cards
supported
4
Maximum supported
Mura IPX Series
3
Maximum supported
D-Series
3
Motherboard Supermicro H11SSL-i
Chipset AMD SP3
Processor AMD EPYC 7251 8-Core Processor, 2100 MHz
Heatsink (for CPU) SOCKET SP3 (Supermicro Part#: SNK-P0064AP4)
System BIOS version 1.3, 2019-06-25
System memory 32 GB DDR4
Chassis Supermicro CSE-842XTQ
Power supply 600 W redundant power supply
PCIe expansion slots

3 PCIe x16 3.0 slots

3 PCIe ×8 3.0 slots
Notes

In the system BIOS main page, go to
Advanced

PCIe/PCI/PnP Configuration

and set
Above 4G Decoding
to
Enabled
.

In the system BIOS main page, go to
Advanced

PCIe/PCI/PnP Configuration

M.2 PCIex4 OPROM

and set
to
Disabled
.

In the system BIOS main page, go to
Advanced

PCIe/PCI/PnP Configuration

and set
VGA Priority to Offboard
.
 In the system BIOS main page, go to
IPMI Tab

IPMI Function Support
 and set to
Enabled
.

Requires installation of Supermicro SuperDoctor® 5 to control the fan speed. Ensure to have the fan speed
set to full speed.

Requires a low profile CPU cooler for the CPU heatsink that can be purchased from Supermicro (Part#:
SNK-P0064AP4).

Slots 3 and 5 are unusable due to mechanical conflict. The heatsink on the motherboard conflicts with the
PCIex16 add-in card gold fingers.

On-board console support with D-Series controllers. Requires 3.05 drivers or later.
Slot
D-Series based controller Third-party based controller
Main Options Main Options
CPU SLOT1 PCI-E 3.0 X8 MURAIPXI-E4JHF A MURAIPXI-E4JHF A
CPU SLOT2 PCI-E 3.0 X16 MURAIPXI-E4JHF A, B MURAIPXI-E4JHF A
CPU SLOT3 PCI-E 3.0 X8 N/A N/A N/A N/A
CPU SLOT4 PCI-E 3.0 X16 D1480 B Third-party graphics hardware A
CPU SLOT5 PCI-E 3.0 X8 N/A N/A N/A N/A
CPU SLOT6 PCI-E 3.0 X16 D1480 A, B Third-party graphics hardware