Matrox Mura D-Series, System Builder'S Manual

Page: 49 / 88

Matrox Display Wall – System Builder’s Guide 49
Advantech PCE-5B12 with PCE-7131 / PCE-7129 SHB
D-Series based controllers Third-party based controllers
Validated Yes No foreseeable compatibility issues
Maximum number of cards
supported
10
Maximum supported
Mura IPX Series
9
Maximum supported
D-Series
4
Motherboard Advantech PCE-7131 / PCE-7129 (SHB)
Advantech PCE-5B12-00A1 (Backplane)
Chipset Intel C246 (PCE-7131 SHB)
Intel C236 (PCE-7129 SHB)
Processor Advantech PCE-7131

Intel® Xeon®E-2278GE CPU@ 3.30 GHz, or

Intel® Core™ i7-9700E CPU @ 2.60 GHz
Advantech PCE-7129

Intel® Core™ i7-6770S, 3.40 GHz
Heatsink (for CPU) 2U CPU cooler
System BIOS version 5.13, 2020-04-09 (PCE-7131)
5.12, 2018-03-13 (PCE-7129)
System memory 32 GB DDR4 ECC Memory (Intel Xeon E-2278GE)
32 GB DDR4 non-ECC memory (Intel i7-9700E/i7-6770S)
Chassis Advantech IPC-623 4U rack mount

Chassis Part#: IPC-623BP-1KZC (for single power supply; includes chassis, fans, and 1200 W power
supply)
Or
Rackmaster 20 slot chassis

Chassis Part#: 010-0163 (includes chassis, fans, and 800 W redundant power supply)

Chassis Part#: 010-0165 (includes chassis, fans, and 1200 W single power supply)
Power supply  1200 W (Advantech part # 96PS-A1K2WPS2; included with Chassis IPC-623BP-1KZC)
Or
 800 W RPSU / 1200 W single power supply is included with the Rackmaster 20 slot
PCIe expansion slots

10 PCIe x 16 2.0 slots (x16 mechanical, x16 electrical)

1 PCIe x16 2.0 slot (x16 mechanical, x4 electrical)
Notes  Choose power cord with IEC C19 plug for Advantech IPC-623BP-1KZC chassis model.

All the dust protectors from the front as well as the sides of the chassis must be removed from the
Advantech IPC-623 chassis.

The Advantech IPC-623 chassis fans must run at full speed.
 Smart fan must be disabled to run chassis fans at full speed. In the system BIOS, go to 
Advanced

HW
Monitor Tab

SYSFAN1 Smartfan Setting

and select
DISABLE
.
 Ensure to have the following settings for GPU. Go to the system BIOS main page 
Chipset

System Agent
(SA) Configuration

Graphics Configuration

and select:

Primary Display

AUTO

Internal Graphics

AUTO
(select
Enabled
for console)
 In the system BIOS, go to
Chipset

System Agent (SA) Configuration

Above 4GB MMIO BIOS Assignment
 and
select
Enabled
.
 On-board console support with D-Series controller. Requires 3.05 or later drivers.

Card placement shown in the configuration table must be followed for better system ventilation.
 Any unused slots must be installed with solid brackets for proper system ventilation.