Matrox Matrox Radient eV-CXP, Installation And Hardware Reference, Page: 20 / 70

20 Chapter 2: Hardware installation
Installing the cable adapter brackets
To install the cable adapter brackets, proceed with the following steps:
1. Make sure that your Matrox Radient eV-CXP board is fastened to the computer
chassis.
2. Attach the two cable adapter brackets to the internal auxiliary I/O connectors on
the Matrox Radient eV-CXP board. When attaching the flat ribbon cables of the
adapter brackets, position each cable so that the black wire is on the same side as
the bracket of the Matrox Radient eV-CXP board.
Note that the two cable adapter brackets are physically identical. For naming
purposes, the cable adapter bracket that you connect to internal auxiliary I/O
connector 1 is the primary cable adapter bracket. The secondary cable adapter
bracket is the cable adapter bracket that you connect to internal auxiliary I/O
connector 2.
3. Slide the bracket of the cable adapter bracket into the opening at the back of the
selected slot.
4. Anchor the bracket to the chassis using the screw that you removed in the previous
section.
Note that the external auxiliary I/O connectors on the cable adapter brackets are
panel mount connectors. If you don’t want to occupy an entire slot for each
additional bracket, you can punch out two holes in the computer chassis, and then
screw the connectors in the holes.
Internal
auxiliary I/O
connector 1
Internal
auxiliary I/O
connector 2