Matrox Extio 3 Series, User Manual

Page: 33 / 111

Matrox Extio 3 Series – User Guide 33
Extio N3208 transmitter or receiver unit
Extio N3208 transmitter unit (Front)
LAN1
 
Connect an RJ45 cable to this connector.
Note: If you’re using link redundancy, make sure the
LAN1
and
LAN2
connectors are connected before enabling the
Link
redundancy
feature.
LAN2
 
Connect an SFP module (RJ45 cable or LC-LC fiber optic cable)
to this connector. For more information,
see “Installing the SFP
module”, page 36 .
Note: If you’re using link redundancy, make sure the
LAN1
and
LAN2
connectors are connected before enabling the
Link
redundancy
feature.
Line In
 
Connect the
Line Out
connector of your computer (host) or of
another audio device (local or remote) to this connector. This
connector supports a 3.5 mm stereo jack.
Line Out
 
Connect the
Line In
connector of your computer (host) or of
another audio device (local or remote) to this connector. This
connector supports a 3.5 mm stereo jack.
Microphone

Connect your microphone to this connector. This connector
supports a 3.5 mm stereo jack.
RS232
 
Control an RS232 device on one of your devices with an RS232
controller connected to device, or with an RS232 controller
sending commands over the network.
If your RS232 device has a DB25 connector, use a DE9 (also
known as a DB9) to DB25 converter to connect your device to
this connector.
USB 2.0
 
Connect a USB device to this connector.
Connector
Tx Rx
Description
Video Out
(DisplayPort 1.1)
USB 2.0