Matrox EpicA Series, User Manual

Page: 6 / 54

6 Matrox EpicA Series – User Guide
3
Insert your Matrox card
a Position your Matrox card over the
expansion slot you’ve chosen.
b Push the card in firmly and evenly until
it’s fully seated in the slot.
c Secure the bracket of your Matrox card
to the computer frame.
Your Matrox card is now installed. Before restarting your computer , connect your monitor or
monitors ( “Connection setup”, page 7 ). After connecting , restart your computer and install your
Matrox software ( see “Software setup”, page 11 ).
Replacing brackets on a low-profile graphics card
Matrox low-profile graphics cards ship with ATX brackets compatible with most systems. The
following explains how to change your standard bracket to a low-profile bracket.
1 Remove the standard bracket from your
Matrox graphics card by removing the
nuts (
a
) on either side of the monitor
connector. Depending on your Matrox
product, you may need to remove a
screw (
b
) on top of the graphics card.
2 Attach and fasten the low-profile
bracket with the two nuts you just
removed.
ATX bracket
Low-profile bracket