Matrix VISIONPRO Quick Start
9
Configuring VISIONPRO
All parameters of VISIONPRO are configured by dialing the relevant command strings from a
station phone connected to the system.
Phone Wizard only allows programming of the basic parameters. For detailed programming, refer
the VISIONPRO System Manual.
Follow the instructions given below to configure the system using the Phone Wizard from the SE
mode.
To enter the Phone Wizard programming mode,
• Dial
1#98-SE Password
.
Where,
Default SE Password is 1234.
Date and Time
To Set Current Date,
• Dial
27-Date-Month-Year-Day
Where,
Date is from 01 to 31
Month is from 01 to12
Year is from 00 to 99 (here, base year is '2000'. Enter '07' for year '2007')
Day is from 1 to 7 where, 1 = Sunday.
To Set Current Time,
• Dial
28-Hour-Minute
Where,
Hour is from 00 to 23.
Minute is from 00 to 59.
Time has three parameters: Hour, Minute and Second. However, the above command
has only two parameters. The third parameter, Seconds will be set as '00' whenever new
time is programmed.
