6
Matrix VISIONPRO Quick Start
• Place the SLTs, fax machine at the desired locations. Connect the SLTs, Fax machine to the
wall jacks.
• Terminate one end of the cable on the wall jack to which the SLT, fax machine is connected.
• From the other end of the wire, strip off about half a centimeter of the insulation.
• Using a blunt pin or a small flat screw driver, push back the levers of the connector.
• Insert the stripped ends of the two wires into the two openings of the connector, with one wire
in each opening.
• Ensure that both wires fit neatly into the opening.
• Release pressure on the levers. Both wires will be held in place by spring clamp action.
If you need to remove the wires,
• Push back the levers.
• Pull out the wires gently.
• Release pressure on the levers.
Power On VISIONPRO
• Check the mains voltage at the power plug from where the power supply is to be fed to the
system.
• Make sure system’s earthing is proper.
• Plug in the power adapter of VISIONPRO into the power outlet. Ensure proper contacts.
Switch ON the system. Observe the reset cycle on the front panel of the system.
Reset Cycle
• As soon as you power ON the system, the PWR (Power) LED on the front panel starts
glowing. The STS (Status) LED starts glowing approximately 5 seconds after power ON.
Thereafter, the STS LED blinks in a cadence of 1sec ON and 1sec OFF.
• The system also feeds Dial Tone to the stations.
• Check for Dial Tone on the telephone instruments connected to the system.
