Matrix T5X-04, Service Manual, Page: 46 / 74

43
9.11 INCLINE MOTOR REPLACEMENT - CONTINUED
FIGURE D FIGURE E
FIGURE F FIGURE G
4) Disconnect the incline motor power cable from the MCB (Figure D).
5) Disconnect the pin from the incline motor (Figure E).
6) Lift the incline motor away from the treadmill (Figure F).
7) Reverse Steps 1-6 to install a new incline motor. NOTE: When installing the new incline motor, make sure to replace the white washers at
the top and bottom (Figure G).
8) Auto Calibration must ALWAYS be run after replacing the incline motor (see Section 3.4).
CHAPTER 9: PART REPLACEMENT GUIDE