Matrix SPARSH VP710, User Manual, Page: 765 / 1046

Matrix SPARSH VP710 User Guide 757
Appendix D - Configuration Parameters
This appendix describes configuration parameters in the configuration files for each feature. The configuration file
is <MAC>.cfg.
Setting Parameters in Configuration Files
You can set parameters in the configuration files to configure IP phones. The <MAC>.cfg file is stored on the
provisioning server. The IP phone checks for configuration files and looks for resource files when restarting the IP
phone. The <MAC>.cfg file stores configurations for a specific IP phone with that MAC address.
Basic and Advanced Parameters
DHCP
Static DNS
Parameter
-
static.network.internet_port.type
Configuration File
<MAC>.cfg
Description
Configures the Internet port type for IPv4.
Note : If you change this parameter, the IP phone will
reboot to make the change take effect.
It works only if the value of the parameter
“static.network.ip_address_mode” is set to 0
(IPv4) or 2 (IPv4 & IPv6).
Default Value
0
Range
Valid values are:
0
-DHCP
1 -PPPoE
2 -Static IP Address
Example
static.network.internet_port.type = 0
Parameter
-
static.network.static_dns_enable
Configuration File
<MAC>.cfg
Description
Triggers the static DNS feature to on or off.
Note : If you change this parameter, the IP phone will
reboot to make the change take effect.
Default Value
0