Matrix SIMADO GFXD1111S, System Manual

Page: 168 / 194

162 Matrix SIMADO GFXD1111S V3 System Manual
System Report
SIMADO GFXD1111S supports generation of system reports. It facilitates the SE to verify the programming done by
him and troubleshoot the problem, if any. The system should be configured in 'Report Generation' mode at the time
of generating reports. (Refer
“Mode of Operation” feature) Reports are generated using Hyper Terminal window and
therefore it is necessary that baud rate, flow control etc is set to correct value.
SE can generate reports of following parameters:
• Port Parameters-FXS
• Port Parameters-FXO
• Port Parameters-Mobile
• System Parameters
SE can check the following values by generating reports of above mentioned parameters:
For FXS Port:
• CLIP Type
• First Digit Wait Timer
• Inter Digit Wait Timer
• Answer Signaling
• Disconnect Signaling
• Hotline
•
Status
• Destination Number
• Delay Timer
• Metering Pulses
•
Type
• Pulse Width
• Call Forward to FXO: When No Reply
•
Destination Number
• No Reply Timer
• Call Forward to Mobile: When No Reply
•
Destination Number
• No Reply Timer
For FXO Port:
• Status
• Disconnect Supervision
•
Open Loop Disconnect Timer
• Ring Cadence Off Timer
• Pause Timer
• Dial Type
• CLI Type
• Answer Supervision
• Disconnect Tone Detection
•
Status
• On time
• Off time
• Line Check Status
For Mobile Port:
• Status
• SMS Indication Status