Matrix SIMADO GFXD1111S, System Manual

Page: 148 / 194

142 Matrix SIMADO GFXD1111S V3 System Manual
Programming the System using SMS
GFXD1111S supports SMS based configuration i.e. it is possible to configure the system by sending SMS to the
system. This method is useful when it is required to configure the system remotely.
How to use?
To configure the system using SMS, SE should enable 'SMS Based Configuration' option and then follow the steps
given below:
1.
Type a text message in your cell phone. Include all the desired configuration commands in the message in
required format.
2.
SMS meant for configuring the system should always start with #*19-SE Password i.e. the command for
entering the programming mode and should end with 00#* i.e. the command to exit the programming
mode.
3.
The commands for configuring the system should be typed between the command for entering and exiting
the programming mode.
4.
Maximum message length of SMS meant for configuring the system is 160 characters.
5.
After typing the message send it to the SIM number that is installed in GFXD1111S.
6.
When GFXD1111S receives this SMS, it will execute the commands in the SMS and thus configure the
system.
For Example: Suppose SE wants to configure following parameters in GFXD1111S using SMS:
1.
Program number in Allowed number list by issuing command:
261-Location Index-Number-#* i.e. 261-01-2630555-#*
2.
Program number in Denied number list by issuing command:
262-Location Index-Number-#* i.e. 262-01-2630630-#*
3.
Program LCR type by issuing command:
411-LCR Type-#* i.e. 411-2-#* (LCR Type 2 = Time Based)
To configure above stated parameters, SE should send following SMS to the Mobile number (SIM Card number
installed in the system) of GFXD1111S:
#*19-1234-261-01-2630555-#*-262-01-2630630-#*-411-2-#*-00#*
As soon as GFXD1111S receives this SMS, it will execute the commands in the SMS.
How it works?
• When SMS based configuration is enable, GFXD1111S will read all incoming messages and if it is found to
be meant for configuration, it will configure the system as described in the SMS.
• Configuring the system using SMS is done only when all the ports of the system are idle.
• When GFXD1111S receives SMS for configuring the system, it will not notify the user even if SMS
notification is enabled.
• The SMS meant for configuring the system will be deleted when all the configuration commands included
in the SMS are executed.
• If during SMS configuration, system is required to be defaulted or restarted than the remaining SMS which
are not executed will be executed once the system is restarted or defaulted.