Matrix SIMADO GFXD1111S, System Manual

Page: 118 / 194

112 Matrix SIMADO GFXD1111S V3 System Manual
Where,
By default, CLI type selected is 'DTMF'.
CLI type 'None' is selected when the exchange does not support any type of CLI or user does not want to detect the
CLI. Detecting CLI takes time and thus the routing of call gets delayed by 2-3 seconds, this delay can be avoided by
using CLI type = 'None'.
Pause Timer:
Pause timer is the time for which GFXD1111S will wait while dialing out DTMF digits on the FXO Port when
character P is detected in the DTMF number string. It is also known as 'Wait Before Dial' timer.
Use following command to program Pause Timer for FXO Port:
217-Pause Timer-#*
Where,
Pause Timer is from 1 to 9 seconds.
By default, Pause Timer is 2 seconds for the FXO Port.
Example: If number string to be dialed out on the FXO port is PPP234 and pause timer is programmed as 3
seconds then GFXD1111S will dial out digit 2 after P+P+P seconds i.e. 3+3+3=9 seconds.
Ring Cadence OFF Timer:
During an incoming call on a FXO port, the ring cadence varies from exchange to exchange and PBX to PBX.
Some times this ring cadence OFF timer is as high as 5.5 seconds. GFXD1111S may consider it as a RING STOP
event. However, in actual condition incoming call is still present. GFXD1111S facilitates programming of the ring
cadence off timer so that the incoming call with quite a long ring off period can also be honored.
Use following command to program the Ring Cadence Off Timer for FXO Port:
215-Ring Cadence Off Timer-#*
Where,
Ring Cadence Off Timer is from 1 to 9 seconds.
By default, it is 4 seconds.
DTMF Out Dial ON Time:
(Refer “System Parameters” feature for details)
Inter Digit Pause Time:
(Refer “System Parameters” feature for details)
DTMF Out Dial Level:
(Refer “System Parameters” feature for details)
CLI Type Meaning
1 None
2 DTMF
3 V.23 FSK
4 Bellcore FSK