Matrix SETU VFX44L, System Manual

Page: 103 / 195

Matrix
103 SETU VFX88L
/
VFX44L V1
System Manual
FXS Port Parameters
What’s this?
For interfacing telephones or Fax etc. at the FXS Port of the gateway,
it is required to set some port parameters for each port. For example,
facility can be provided to enable/disable a Port. Disabling port is
required in case of Hardware failure.
How to program?
• Refer VFX88L
/
VFX44L Web Jeeves.
• Click on ‘
FXS Port Parameters
’.
• Program following parameters for all 1 to 8 FXS-ports (1-4 for FXS
Ports for VFX44L) as required.
Status:
• Select disable if you want any FXS Port not to be used.
• Gateway will route the call from the port only if the port is enabled.
• When port is disabled and you go OFF-Hook, you will get error
tone. The Gateway will not allocate the port for routing the call if
port is disabled.
By default, all port will be Enable.
Name:
Enter here the Name of maximum 12 characters, may be with ASCII.
• It is used as Display Name for making an outgoing call on any SIP
Account.
• The name entered here is sent on the SIP Account as the Display
name in the SIP message.
Default: Blank.
Number:
• Enter here Maximum 4 digits number of the FXS port using digits
Blank, 0-9, *, #.
• This number is used only when there is a Non-Proxy SIP Account
call.
• It is send on the Non-proxy SIP Account call in the SIP message
Default: 2001 to 2008 for FXS1 to FXS8 respectively (VFX88L).
Default: 2001 to 2004 for FXS1 to FXS4 respectively (VFX44L).