Matrix NAVAN CNX200, System Manual

Page: 454 / 1388

444 Matrix NAVAN CNX200 System Manual
• When extension number of the calling extension is blank, and the ‘Send CLI Option’ programmed for
the SIP Trunk is other than “SIP ID”, then also SIP ID will be sent as CLI.
• When Emergency numbers are dialed out using a SIP Trunk which has CLIR configured as the ‘Send
CLI Option’, the system will either send the DDI number/Pilot number or the SIP ID accordingly in the
FROM field as the CLI to the remote party so that emergency services can locate the user by its identity
(CLI). However, DDI number/Pilot number will be given extra preference over the SIP ID, if available.
3.
If you want anonymous calls to be accepted by this SIP trunk & routed to programmed destination, then
select the
Accept Incoming Calls without CLI check box. Default: enabled.
P-Asserted-Identity/P-Preferred-Identity for Outgoing calls
1.
Click P-Asserted-Identity/P-Preferred-Identity for Outgoing calls to expand.
2.
Configure the following P-Asserted-Identity/P-Preferred-Identity for Outgoing calls parameters as
provided to you by your Service Provider.
• Select Add P-Asserted-Identity/P-Preferred-Identity check box, if supported by your Service
Provider.
• Select P-Preferred-Identity or P-Asserted-Identity as Identity .
• Select the desired Caller ID option:
• SIP ID: If you want the SIP ID configured on the SIP Trunk to be displayed as the Caller ID.
• Calling Party Wise: If you want the Calling Extension Number (the number of the extension
making the outgoing call through the SIP trunk) to be displayed as the Caller ID.
• Fixed Number: If you want a specific number to be sent as the Caller ID. When you select this
option, you must also define the number to be sent as the Caller ID.
The Fixed Number may consist of a maximum of 40 characters. Default: SIP ID.