Matrix Vision mvBlueLYNX-X, Technical Manual, Page: 45 / 236

Figure 17: wxPropView - setting the addiitional digital I/Os
As shown in the figure, via LineMode you can set the mode of the I/O - either Output or Input. When
choosing Input, you can set the mv Input Threshold either to TTL or PLC.
8.3.3.2 Characteristics when used as digital outputs
The high-side switches has the same characteristics as the digital outputs of the circular connector male
(Power / Digital I/O). Additionally,
the outputs are protected against loss of ground, •
an external power supply is necessary (VCC_HSD signal) either via
pin 1 of this female connector or ♦
pin 10 of the circular connector male (Power / Digital I/O) (which powers the output 1..4 as
well but only up to 3A output load)
♦
•
Figure 18: Setting of digital outputs
8.3.4 RJ45 network connector (Fast Ethernet / 100 Mbit)
With the -POE option, the camera is a class 2 compliant PoE device and pin 4,5 (V+) and 7,8 (V-) are
connected.
mvBlueLYNX-X Technical Manual
MATRIX VISION GmbH 22 April 2016 Version - 1.49 35