Matrix Vision mvBlueCOGAR-P Series, Description, Page: 1 / 2

MATRIX VISION GmbH | Talstrasse 16 | DE ­ 71570 Oppenweiler
Telefon: +49­7191­9432­0 | Fax: +49­7191­9432­288 | www.matrix­vision.de
Mail: info@matrix­vision.de
Subject to change without notice / Technische Änderungen vorbehalten – 08/2009
1
Changing optical filter
The description can be used for following products:
mvBlueCOGAR­P series
mvBlueFOX series
mvBlueLYNX series
mvBlueLYNX­M series
You will need following utilities to change the filter:
pointed forceps
to remove the rubber locking ring
screw driver or similar
to remove the filter frame
allen wrench, 0.9mm
lens
PC with installed driver
Please work under the clean air while changing the filter. Otherwise, dirt on the image
area could be the consequence.
Step 1: Demounting of mount ring nut
For demounting of the mount ring nut, please
1. unfix the 3 set screws on the front plate with the aid of the 0.9mm allen wrench
( in figure 1). Afterwards
2. turn the mount ring nut anti­clockwise from the front plate ( in figure 1).
Step 2: Demounting of filter frame
For demounting of the filter frame
1. turn the filter frame anti­clockwise from the front plate ( in figure 1) using a screw
driver or a similar tool. Set the screw driver at the groove of the filter frame.
Step 3: Changing the filter
A rubber locking ring fixes the filter in the filter frame.
1. Remove the rubber locking ring using a pointed forceps ( in figure 1). Afterwards,
2. change the filter ( in figure 1). Finally,
3. fix the rubber locking ring again.
I
3
4
5
1
2