matev SPR-HM-100, Original Operating Manual, Page: 28 / 29

List of illustrations
Page 28
11 List of illustrations
Fig. 1: Mounting categories ........................................................................................................................... 9
Fig. 2: Mark the cutting point Fig. 3: Sawing the universal joint shaft to length ..................................... 10
Fig. 4: Sawing off the profile tube Fig. 5: Deburring of the cut edges .................................................. 10
Fig. 6: Greasing the profile tubes ................................................................................................................ 10
Fig. 7: Allow the locking disk to lock in place .............................................................................................. 11
Fig. 8: Drive kit, hydraulic ............................................................................................................................ 11
Fig. 9: Hydraulic dosing flap actuation ........................................................................................................ 12
Fig. 10: Electric dosing flap actuation .......................................................................................................... 12
Fig. 11: Lights for 80 cm spreader width ..................................................................................................... 13
Fig. 12: Lights for 100cm spreader width .................................................................................................... 13
Fig. 13: Lights for 120cm spreader width .................................................................................................... 13
Fig. 14: Routing of cables ............................................................................................................................ 14
Fig. 15: Work light ........................................................................................................................................ 14
Fig. 16: Spreader with tarpaulin and one, two or no additional add-on sections ........................................ 15
Fig. 17: Wheel set mounted on spreader .................................................................................................... 15
Fig. 18: Screw-on point, rigid part of dosing rail Fig. 19: Seed rail mounted ........................................... 16
Fig. 20: Seed rail mounted .......................................................................................................................... 16
Fig. 21: Broom and shovel holder Fig. 22: Broom and shovel lock .......................................................... 17
Fig. 23: Folding down the dosing rail ........................................................................................................... 21
Fig. 24: Pedestal bearing on left in direction of travel ................................................................................. 22
Fig. 25: Open chain housing........................................................................................................................ 22
Fig. 26: Lubricating the bolt ......................................................................................................................... 22
Fig. 27: Regreasing the spread rail ............................................................................................................. 23
Fig. 28: Universal joint shaft ........................................................................................................................ 23
Fig. 29: Loosening the shaft ........................................................................................................................ 24
Fig. 30: Opening the chain housing ............................................................................................................. 24
Fig. 31: Pulling the agitator shaft out of the box spreader ........................................................................... 24
Fig. 32: Agitator shaft .................................................................................................................................. 24
Fig. 33: Replacing agitator fingers ............................................................................................................... 25
Fig. 34: Agitator shaft in box spreader ........................................................................................................ 25
Fig. 35: Technical data ................................................................................................................................ 26
Fig. 36: Accessories .................................................................................................................................... 27