7
Page 22
7
Maintenance
General information about safety during maintenance (oil change /
oil filter change)
Switch off the tractor, remove the ignition key and set the hand brake before
working on the engine PTO shaft.
Repairs to components under tension or pressure (springs, accumulators)
require sufficient knowledge and proper tools, and must always be carried out
by specialists.
Properly reattach all protective devices that have been dismounted after
executing the maintenance tasks. Replace any worn or non-functioning safety
devices!
Personal injury and material damage to the tractor and implements can occur.
Before each use of the implements check all safety-relevant parts and the
hydraulic connections.
Danger of crushing due to moving parts.
Never reach into the crushing hazard zone if parts are moving or can move.
Wear suitable protective clothing (goggles, gloves, overalls)!
Change oil / oil filter only after the engine PTO shaft has cooled down!
Danger of burns!
After the first 20 hours of operation check all screw and bolt connections.
Subject the implement to regular maintenance.