Quick Start Guide
MAXFLEXPRO Tablet
Included Accessory Checklist
A tablet for showing test results.
MAXFLEXPRO Tablet
Power Adapter
To supply power to the tablet
through connection to AC outlet.
Password Envelope
A piece of paper bearing
Product S/N and Verification Code,
which is required for your VCI
activation.
Vehicle Communication Interface
(VCI) Dongle
A device for accessing vehicle data.
Diagnostic Cable
To connect the VCI dongle and the
test vehicle.
The tablet acts as the central processing system, which is used to receive and analyze the live
vehicle data from the VCI dongle and then output the test result.
2202032-16
2202032-16
MDMAXFLEXPRO
MDMAXFLEXPRO
VCI (Vehicle Communication Interface)
Working Principle
1. Charging & Turning On
After use, please remember to unplug it from the DLC port.
The VCI dongle works as a vehicle communication interface device, which is used to connect
to the vehicle’s DLC (Data Link Connector) port via the diagnostic cable to read the test data
and then send it to the tablet.
LED Indicators
It is defined as follows:
3.Tablet Communication:
2.Vehicle Communication: While the VCI dongle is
communicating with the vehicle, the LED lights up
and flashes. Otherwise, it will not illuminate.
1. Power: It illuminates solid red when the VCI dongle is
powered on.
ž
It illuminates red when the VCI dongle is connected
to the tablet via data cable (not included).
ž
It illuminates blue when the VCI dongle is working in
wireless (BT) communication mode.
(To connect the diagnostic cable.)
DB-15 Diagnostic Connector
Data I/O
Port
(To connect it to the tablet to perform
diagnosis via the data cable.)
*Note: When the VCI dongle is connected to the tablet via data cable (not included), the
system will switch to USB mode automatically and the wireless communication will be
disabled.
Internet
Car
Motorcycle
To Vehicle’s DLC Port
Wi-Fi
The following illustration demonstrates how the MAXFLEXPRO diagnostic system works.
1. Connect one end of the included power adapter to Type-C charging port of the tablet, then
connect the other end to the AC outlet.
2. After charging is complete, disconnect the power adapter from the AC outlet. Press
the
[
POWER]
button on the
tablet, the system starts initializing and then enters the home screen.
*Warning: Please use the included power adapter to charge your tablet. No responsibility
can be assumed for any damage or loss caused as a result of using power adapters other
than the one supplied.
*Note: If the VCI dongle is successfully activated, the tablet will
automatically obtain the VCI ID and connect to it. In this case it is
not necessary for the user to manually configure it again. For
details on how to activate the VCI dongle, refer to Section 4.
Register & Update.
Quick Start Guide
Type-C Charging Port
Data Transmission Port
Memory Card Slot
Ambient Light Sensor
Charging Indicator
Microphone
Microphone
Front Camera
Power/Screen
Lock Button
Volume Buttons
10.1" Touch Screen
Camera Flash
Rear Camera
Audio Speaker
Foldable Stand
Audio Speaker
(Reserved for
and
add
-
on
modules,
other USB devices use only.)
(Reserved for charging or transferring data.)
(To store the memory card
for storage extension.)
(Red means Charging, and
Green means Fully Charged.)
(
Flip out it to any angle and work comfortable
at your desk, or hang it on steering wheel.)
VCI Dongle
or
MAXFLEXPRO Tablet
BT
Power
Vehicle Communication
Tablet Communication
Summary of Contents for MDMAXFLEXPRO
Page 3: ......
