MAS4
rev 10/24/18
MAS4
EZ SET™ TABOURET D’ATELIER PNEUMATIQUE PROFESSIONNEL
SILLA DE TALLER PROFESIONAL NEUMÁTICA EZ SET™
PROFESSIONAL SHOP SEAT
EZ SET
™
PNEUMATIC
Tools Needed for Assembly:
14mm Wrench
Assembly Instructions:
1. Attach all five (5) casters to bottom of round metal base. The bottom of the base is opposite the side with the center round hole.
Insert the threaded stem of each caster with lock washer through the holes and tighten nuts onto stem with a 14mm wrench.
2. Slip the painted end of the lift cylinder into center hole on top of round metal base. To avoid damaging the cylinder, do not force
or hammer cylinder into hole. The first time you sit on the seat, the cylinder will lock itself into place automatically.
3. Place seat on top of the unpainted end of the lift cylinder. As with the lift cylinder in Step #2, do not force or hammer the seat
onto cylinder.
4. To lock seat and cylinder into place, slowly add your weight to seat by sitting on seat for approximately 10 seconds.
5. You’re done!
Care Instructions:
Your professional shop seat is designed to give you worry-free service with little to no maintenance. There should be no need for
periodic oiling or maintenance of the seat or cylinder. Simply keep clean with damp cloth. Avoid contact with harsh chemicals.
• Replacement air cylinder available as part # RS8509AC.
• Replacement caster with nut and washer available as part # RS8509WH.
• Replacement seat available as part # RS8509MST.
• Replacement bolt kit (5 nuts and washers) available as part # RS8509WK.
• Replacement plate with seat lever available as part # RS8509SL.
Copyright © Professional Tool Products, 2018
All rights reserved.
