PAGE 1 OF 1 | AU SUPPORT 1800 237 425 WWW.MATCHMASTER.COM.AU
14MM-SM90-5G
INSTRUCTION MANUAL
Contents
1. Introduction
1.1. Product Description
1.2. Package Contents
2. Technical Specifications
3. Hardware Installation
Installing the smart amp
Duplicate channel switch off
Duplicate channel switch on
LTE filtering
How autoscan works
How to force channel scan
4. Safety Instructions
5. Conditions of Warranty
1.Introduction
1.1. Product Description
• Scans all channels, amplifies the weak signals while
keeping the strong channels
• All output channels have an equal and stable output
power
• Treats even the most difficult situations with
adjacent channels
• Channels with the same frequency can be amplified in and
re-located to the LTE band (switchable)
• Fully automatic channel scan and process function upon
double power start-up.
• Fully automatic recognition of the applied country
channel plan
• SAW filters for LTE (4G or 5G) protection on all inputs
• Outdoor weatherproof mast-head housing
• DC Power over coax
• All ports ESD protected
1.2. Package Contents
• 1 Smart Amp
Installing the Smart Amp
• Connect your Terrestrial antennas to the Smart Amp*
• Connect the Smart Amp output to the Power Supply
• Connect your TVs to the Power Supply
Important: Mount the module vertically to the mast or a wall
in a well-ventilated room and leave a minimum space of 15
cm around the product to guarantee a maximum ventilation
of the product
* The Smart Amp does not allow pass-through DC-power for
pre-amplifiers or active antennas
How autoscan works
• Plug in Power Supply
• Status LED will blink green when scanning
• Status LED solid green when autoscan ready (This can
take up to 20 seconds)
• Status LED red when error during scan. Unpower and
repower within 6 seconds to restart autoscan
• WARNING:
do not turn off the power during SCAN
How to reprogram or force channel scan
• When a power outage causes missing channels on your
TV, a reset is needed
• Reset: pull out the power supply and put it back in within
6 seconds
• The status LED will blink when re-scanning
• If a power interruption lasts longer than 6 seconds, there
is no channel scan and the initial settings are kept
• Important note for installers! Make sure the end-user or
installer can easily and safely unpower and
repower device
2. Technical Specifications
LTE Filtering
2. Hardware Installation
Inputs
3
Outputs
4G/5G (CH51)
Frequency range
VHF BIII + UHF Automatic
channel plan selection
LTE Band Rejection
>40
Output
1
Output Power
90 dBuv
LTE band Re-use
L2 = CH52-69 (694MHz-862MHz)
Switch ON-OFF
Adjacent channel
isolation
>35
Input sensitivity
40 dBuv
Operating temperature -20 to +50
Power Supply
External power supply
Power
12V/300mA (DC over coax)
(9VDC-18VDC)
Unplug power supply
Less
than
6 sec
Plug in power supply
