MASTERFLEX L/S Variable-Speed Modular Drives Operating Manual
2-1
Masterflex
Section 2
Setup and Drive Operation
•
The drive should be mounted on a flat horizontal surface, and no more
than two (2) Pump Heads should be added for 600 rpm drives or four
(4) Pump Heads for 100 rpm drives.
•
The ambient air temperature should not exceed 104° F (40° C) and
adequate air flow should be provided for.
CAUTION: Do not block the rear panel of the pump drive. The
power cord must always be easy to disconnect.
1. Mount pump head and load tubing. (See pump head manual.)
2
Connect the drive motor cable to the receptacle on the rear side of the
controller.
3. Connect the AC power input line cord to the AC receptacle.
4. Selecting motor direction turns pump on.
5. Adjust flow rate with speed control potentiometer.
Before Starting Drive
Mounting the
Pump Head
A
B
C
Figure 2-1.
Front View of the Controller
A.
Forward-Off-Reverse Switch
B.
Power On Indicator
C.
Speed Control
