29
TM
AD
JUS
TMENT
S
BEVEL STOP ADJUSTMENT
NOTE:
To ensure accurate cuts, alignment
should be checked and adjustments made
prior to use.
90° (0°) Bevel adjustment (Fig. 17, 18)
• Loosen bevel locking handle (1) by lifting
up and tilting the cutting arm while pushing
in the bevel detent pin (6 - Fig. 18) against
the 0° bevel stop. Tighten the bevel locking
handle (1). (Fig. 17)
• Place a combination square (2) on the mitre
table with the rule against the table and
heel of the square against the saw blade.
• If the blade is not 0° to the mitre table,
loosen the three adjustment bolts (3) at the
rear of the unit with a 4 mm hex wrench.
Unlock the bevel locking handle (1) and
adjust the cutting arm zero degrees to the
table. After alignment is achieved, tighten
the three adjustment bolts (3) and press
down on the bevel locking handle (1) to
secure the cutting head.
90° Bevel pointer adjustment (Fig. 18)
• When the blade is exactly 90° (0°)
to the table, loosen the bevel indicator
screw (4) using a star-head screwdriver.
• Adjust bevel indicator (5) to the “0” mark
on the bevel scale and retighten the screw.
Fig. 17
1
2
3
Fig. 18
4
5
View from left front of machine
WARNING!
• To avoid injury from an accidental start, make sure the switch is in the
OFF position and the plug is not connected to the power source outlet.
6
TM
