25
TM
REMOVING AND INSTALLING THE TABLE
INSERTS (Fig. 10)
• To remove, loosen and remove the six
screws (1) on the table inserts (2) with
a star-head screwdriver and remove the
inserts.
• To install, reposition the table inserts, install
the six screws and tighten.
• Check for blade clearance by moving the
slide carriage through the full motion of the
blade in the table slot.
Fig. 10
1
2
WARNING!
• To avoid injury:
- Always unplug the saw to avoid accidental starting. Remove all small
pieces of material from the table cavity before performing any cuts.
The table insert may be removed for this purpose, but always reattach
the table insert prior to performing a cutting operation.
- Do not start the sliding compound mitre saw without checking for
interference between the blade and table insert. Damage could result
to the blade, table insert or turntable if blade strike occurs during the
cutting operation.
A
SSEMBL
Y
