CLKTCD12 User Manual
a
© Masterclock
®
, Inc 2006-2007.
Rev 1.2.0 May ‘07
http://www.masterclock.com
APPENDIX B - MOUNTING
The CLKTCD12 is designed for surface mounting on a wall.
Power and/or low voltage signal wiring should be provided and installed according to
local electrical codes to access the clock from the rear.
A mounting bracket is supplied which has been designed to fit on either a standard 2”x 4”
or 4” x 4” conduit box.
Mount the bracket on the wall/conduit box and attach the power & signal cables, secure
the clock to the bracket using the retaining screw.
Caution : Do not route power or signal cables between the case and the wall (along
the exterior of the wall), which may pinch the power or signal cable and create a
hazardous condition.
A dimensioned drawing has been provided to show a keep out zone for the rear of the
clock. In order to allow the clock to be mounted flush against the surface of the wall, do
not route wires or connectors in the keep out zone
.
In addition, a template of the mounting bracket has been provided with the clock to
located the center of the wiring box/compartment relative to the center of the clock.
Summary of Contents for CLKTCD12
Page 26: ...CLKTCD12 User Manual 23 Masterclock Inc 2006 2007 Rev 1 2 0 May 07 http www masterclock com...
Page 37: ...CLKTCD12 User Manual b Masterclock Inc 2006 2007 Rev 1 2 0 May 07 http www masterclock com...
Page 38: ...CLKTCD12 User Manual c Masterclock Inc 2006 2007 Rev 1 2 0 May 07 http www masterclock com...
Page 39: ...CLKTCD12 User Manual d Masterclock Inc 2006 2007 Rev 1 2 0 May 07 http www masterclock com...