5 |
P a g e
Helios 75K Floodlight System – User Manual
4.
O
PERATION
I
NSTRUCTIONS
Injury to personnel may occur from looking directly at the energized
light source or from physically touching the light body, which may be
hot.
4.1.
Instructions for connecting the Light Panel Cable
4.1.1.
Verify cleanliness of the connectors.
4.1.2.
Connect the Light Panel Cable to the Power Console, ensuring the keyways are
aligned correctly.
4.1.3.
Lightly hand-tighten the connector.
4.1.4.
For downward lighting, connect the Carabiners to
the clips on the Light Panel nearest to the cable
connector, when installed.
4.1.5.
For horizontal lighting, remove the two (2) 5/16”
bolts, Nordlock washers, and clips and reinstall in
the two holes nearest to the outer diameter of the
light panel and connect the Carabiners.
4.1.6.
Ensure slack exists in the cable when the Light
Panel is free-hanging, as shown.
This is done by
sliding the cable strain relief upwards or
downwards on the cable.
Injury to personnel may occur IF the energized panel is touched while
operating. Allow a minimum of 15 minutes for the light panel to cool
down prior to handling.
4.2.
Instructions for turning ON the light panel
4.2.1.
Verify the Dimmer Control knob is fully turned to the “CCW” position.
4.2.2.
Verify the light panel is properly and safely positioned (i.e. away from personnel,
combustible materials, etc.) and installed on the Guide Stud Mount.
4.2.3.
Plug the power cord into a properly rated electrical outlet.
4.2.4.
Depress the Power “I/O” rocker switch to turn on the light.
4.2.5.
Slowly turn the Dimmer Control knob “CW” to the desired light level.
IMPORTANT INFORMATION:
The Helios-75K light panel is equipped with an automatic thermal regulation control
circuit which protects the components from overheating and damage. Water is the ideal
coolant to permit the light panel to operate continuously at 100% power. When
operated in open air, the Helios-75K will slowly reduce output power to maintain safe
operating temperatures. After extended use in open-air the output level will be at
approximately 35% power.
