Installation & Operation Manual | MI-HORIZON3D
©
MASTERIMAGE 3D, Inc.
26
8.2.4. IMB Configuration Settings
Projector configuration settings when using an IMB (Integrated Media Block) are slightly
different; an example of this is given below for a Christie projector and a Doremi IMB. The
changes are highlighted in bold; other projector/IMB manufact
urers’ configurations may vary
slightly. Contact the respective manufacturers for specific information.
Config. 1
Input = IMB-Internal
Data Format = 4:4:4 (RGB)
Source File = Based on content
reso aspect ratio (1998x1080
Flat, 2048x858 Scope, etc.)
Screen File = Site-specific (typically
Flat or Scope based on content)
Use PCF = not selected (unchecked)
Lamp File = Site-specific
ILS File = Site-specific
Auxiliary Lens = Site-specific
–
Selected if Anamorphic Lens or WCL
needed, otherwise unselected
Config. 2
Measured Color = Site Specific
(Create on-site)
Target Color =
DC28_DCI_XYZE_314_351
Color Space = Unity RGB
Gamma = Gamma 2.6
LUT-CLUT = Linear_9x9x9
Scan Type = Progressive
LD Bypass = Selected (this sends
IMB output directly to ICP. This is
required if no LD is installed)
3D Control
Enable 3D = Selected
3D Sync Input Mode = Use
Selected Input Port (polarity = true)
Frame Rate N:M = 6:2
L/R Display Sequence = Left (L1R1
L2R2)
3D Sync Polarity = True (If left/right
eye images swapped set to Inverted)
Dark Time = 350
Output Delay = -100
Phase Delay = 0
Barco Series II projectors have a pre-installed 3D configuration file for the settings required
by the MI-CLARITY3D system. It is possible to select this file rather than making fully
manual entries, but editing of Dark Time and Output Reference Delay would be required.
