19.9 Assembling the flush ring of a single mechanical seal system
The arrow shows the position of the flush ring in the end
shield. To access the ring, please follow the instructions
on See Disassembling the support / Changing the nozzle
orientation on page 31 .
The component parts of the flush
ring for the single mechanical seal
system.
The picture shows the foot plate turned through 180° to prevent the pump from
falling, because the housing is not attached.
Flush ring completely assembled with lip seal and O-Ring.
The flush ring in the back of the end shield. This is used with the single mechanical seal system. A lip seal
is placed in the ring in the same way as a flush ring for a flush system.
l
Put the O-Ring in place as shown.
19.10 Assembling the back seal in a double mechanical seal system
The component parts of the back seal assembly.
38
m-certa-en-08
