User Manual
32
40005E (Enhanced Bargraph Indicator)
REF NO: m42B/om/101
Issue No: 02
7.2 Menu Parameters- In Detail
Note :
For All modes, Ch-2 and Ch-All will be displayed for Dual Channel Bargraph only.
For Single Channel Bargraph, the value will be stored for Channel-1 by default.
Run Mode :
Following parameters can view or change during run time.
Immediately after powering, unit will run in Auto Mode
By pressing
Enter
in run mode, the menu goes into the settings of main menu.
By pressing and holding
Decrement Key
in run mode, relay acknowledgement can be done.
Other Modes :
For entering in Menu press Menu/Enter key in RUN mode. There are total Four modes in Menu. By
pressing increment or decrement key, mode can be changed. To enter into any mode press
Menu/enter key again.
1. Program mode
2. Configuration mode
3. Calibration mode
4. Security Mode
The tables below show the description and menu detail of the all the modes. In general to enter into
any menu Or to edit sub menu, press Menu/Enter key. To change the submenu parameter press
increment or decrement key. To come out from any menu press Esc key.
1 ) Program Mode :
Pressing MENU key CHANNEL window shows
Prog
(Prog) message. Press MENU key again
CHANNEL window shows
pWd
(PWD) message(if and only if password is set other than zero ,
Otherwise it will enter into sub menu), press MENU Key to enter into edit mode of password and
then press INCREMENT key or DECREMENT key to modify the password and then press MENU
Key to enter into Program Mode. CHANNEL window shows
ASP.1
(ASP.1) message. By
pressing MENU Key, CHANNEL window shows
CH-1
(CH-1) message. Means it is asking which
channel value needs to be changed. By pressing MENU key again, CHANNEL window shows the
ASP.1 value of channel number 1. Then use MENU Key to enter into editing mode and use
INCREMENT and DECREMENT key to modify value for channel 1 . OR press ESCAPE key and
then press INCREMENT key to change Set-point 1 for Channel 2. After pressing INC key many
times, the message on Channel Window shows
CH.Al
,(CH. AL) which means user can modify
parameters for all channels at once(
AL
= ALL). ESCAPE KEY is used to come out of ASP.1
setting.
