Maserati Grecale 2022, Owner'S Manual

Page: 298 / 324

8
296
Maintenance and Care
Fluid Level Check for Transmission
Cooling System
The coolant contained in the reservoir of
this system is the same as the one used
for the cooling system of the engine.
For the preparation of the mixture of
water and antifreeze and for the control
of the level, proceed as shown in the
“Engine Coolant Level Check” of this
chapter.
Engine Air Filters Replacement
Contact the Service Network to have
the air filters replaced.
A/C Air Filter Replacement
Contact the Service Network to have
the A/C air filter replaced.
Wiper Maintenance and Blades
Replacement
Windshield Wiper Arms Lifting
When the windshield wiper arms are in
rest position it is not possible to check or
replace the blades as they remain under
the engine hood.
To service the blades it is necessary
to move the wiper arms in "Service"
position. To activate this function,
deactivate the windscreen wiper (ring in
position
0 ) before setting the ignition
device to STOP .
This function can only be activated
within 2 minutes of setting the ignition
device to
STOP .
To activate this function, move the lever
upwards (unstable position) for at least
three seconds.
In this way it is possible to lift the arms
for cleaning or replacing the wiper
blades.
If, after using the function, the ignition
device is set back to
ON with the blades
in a position other than rest position (at
the base of the windscreen), they will
only return to rest position following a
command given using the stalk (stalk
upwards, into unstable position) or when
a speed of 5 km/h (3 mph) is exceeded.
WARNING!
It is dangerous to operate or service
the wiper blades with the windshield
wipers in an active position (any
position different from “0”) and with the
ignition device in the ON position. The
rain sensors may suddenly activate
the wipers. Always use the “Service”