Marzhauser Sensotech PROFILER ST, Operating Manual

Page: 150 / 196

150
Operation Operating Manual
EN
Corr enable/disable position correction
Period
SSI: counting step 0.0976 µm is preset
(not changeable)
TTL (RS-422): enter counting step ac-
cording to quadruple evaluation in mm
1Vss: enter period length of the input
signal in mm
SAVE save settings
ESC return to Setup menu
6.7.7 COM (Data / Interface)
In the
COM (Data / Interface)
menu you can configure the
serial PC interface of the PROFILER ST and enable/disable the
button .
NOTICE
Faulty data transmission and measurement from incorrect
configuration!
When the PROFILER ST and PC are connected to each other
over the RS-232 interface, you must enter the same baud rate
selected on your PC when configuring the PROFILER ST.