Martin Imager Series, Operator'S Manual

Page: 33 / 84

Stand-Alone show playback 33
Stand-Alone show
playback
Starting show playback
1 From the top level of the control menu, scroll to S A and press [enter].
2 Scroll to S A in the top level of the menus on the control panel and press
[enter].
3 Scroll to r u n and press [enter].
4 Scroll to O n and press [enter].
When the show starts to run the current scene number will appear in the
control panel display (unless the PEr/dIS menu has been set to OFF, in
which case the display will switch off two minutes after the last key is
pressed).
Important! Execution of the pre-programmed scenes in a loop will
automatically resume when the fixture is powered-on if stand-
alone is enabled and the automatic lamp-on (PEr/ALO) function
is enabled (see “Automatic lamp-on” on page 22).
Show Execution with the IR remote
control
The Run/Stop button on the IR remote control toggles scene execution
on/off on fixtures that are selected (see“Fixture selection” on page 31).
Scenes execute in a continuous ascending loop.
All remote control functions except Run/Stop are disabled during show
execution.
If the Store Remote Status option (see “Store remote status (SrS)” on page
22) is enabled, then the Run/Stop button will also toggle the
S A / r u n
option to O F F or O n , so that next time the fixture is powered on it will
automatically start (or not start) the Stand-Alone show.