Martin Imager Series, Operator'S Manual

Page: 20 / 84

20 General operation
Control panel
The control panel is used to set the fixture address and other settings. It can
also be used to operate the fixture in a limited way manually for testing and
service purposes.
The control panel will (by default in the personality settings) be deactivated
and switch off after 2 minutes if no buttons are pressed. When inactive error
messages will still be displayed (provided that this has not been deactivated
in the fixture personality settings). To reactivate the display press one of the
buttons for two seconds and release it.
Navigating the control menu
The control panel displays the fixture address at the top of the menu. If there
are any error messages these are displayed as well. To get to the top of the
menu, press [menu] repeatedly. From the top, press [menu] to enter the
main menu. Press [up] or [down] to scroll through menus and press [enter]
to view submenus. To activate a setting or function, press [enter]. To return
to the previous menu or to escape without making a selection, press [menu].
Inverting the display
Press [up] and [down] at the same time.
Menus
The control panel menu is detailed in “Control menu structure” on page 66.
They are described at a high level here.
Address menu (Adr)
Depending on the setting in the Profile menu (see “Profile menu (Pro)” on
page 21) the Address menu is used to set either a:
• DMX control address (1-512), where a fixture will be controlled by DMX
signals from a DMX control device.
• IR fixture ID number (0-9), where a fixture will be programmed using an IR
remote control.