INSTALLATION
The grip of the blade lever (2), clamping wheel (8), and back gauge crank with screw (11) are packed sepa-
rately in a box with the machine. Please install these parts right away. The chassis and stand of the machine
should to be connected as follows:
1. Set up the legs in a way that the 4 threaded pins point upwards.
2. Assemble the stands by matching the color label on each corresponding part.
3. Place the chassis onto the assembled machine stand.
4. Fit the washer over the threaded pins and tighten the hexagonal nut using a 13 m/m wrench.
5. Fit two batteries (size D) into the battery holder on the underside of the chassis.
OPERATION
Do not attempt to operate the 620RC until you have read and thoroughly understand this manual.
The
following procedure should be followed when loading, cutting, and unloading paper from the 620RC.
1. Make sure the safety cap is in place and raise the blade lever until it is locked in its top position.
2. Lift the front safety guard and place the paper stack beneath the blade from the front of the trimmer. Push
the paper stack along the paper alignment guide until it comes to rest squarely against the back gauge and
side gauge with scale.
3. Push the back gauge crank toward the cutter to engage. Turn the crank handle clockwise to bring the back
gauge toward the blade until the desired paper measurement is reached. Use the fine adjustment scale
behind the back gauge crank to insure accurate measurement to within .5mm.
Chassis
Legs
Threaded Pins
Install these first
5
Batteries
https://www.supplychimp.com/