1 INTRODUCTION
Thank you for purchasing a Martin Audio CS265P, a powered sub-bass
system designed to be used with the C115 and C516 Contractor Series
loudspeakers. It incorporates two powerful 6.5" (165mm) drive units in an
ultra-compact enclosure powered by an internal 150 watt amplifier.
2
UNPACKING
Each Martin Audio loudspeaker is built to the highest standard and
thoroughly inspected before it leaves the factory. After unpacking the
system, examine it carefully for any signs of transit damage and inform
your dealer if any such damage is found. It is suggested that you retain
the original packaging so that the system can be repacked at a future date
if necessary.
Please note that Martin Audio and its distributors cannot accept any
responsibility for damage to any returned product through the use of
non-approved packaging.
3
FEATURES
The CS265P has the following features:
150 watt bi-polar complementary output stage.
Differential balanced, summed, dual XLR inputs.
In-built limiters, to ensure the power module cannot clip.
Auto signal ramp-up on switch on. This ensures that the sub-bass
output is brought up to its pre-set level over a two second period.
Full protection against thermal overload.
Martin Audio – CS265P
E
NGLISH
2
This equipment conforms to the requirements of the
EMC Directive 89/336/EEC, amended by 92/31/EEC
and 93/68/EEC and the requirements of the Low
Voltage Directive 73/23/EEC, amended by 93/68/EEC.
Standards Applied
EMC
Emission
EN55103-1:1996
Immunity
EN55103-2:1996
Electrical Safety
EN60065:1998
CONTENTS
<
>
GUIDES
