Martin Audio CDD Series, User Manual

Page: 34 / 64

CDD User Guide V1.1
34
CDD
USER GUIDE
MOUNTING WITH A YOKE ASSEMBLY
Yoke assemblies CDDYA10, CDDYA12 and CDDYA15 may be fitted to Models CDD10, CDD12
and CDD15 respectively, if a yoke mounting arrangement is preferred. Note that due to the
weight of the enclosure, yoke mounting is the only method available for Model CDD15.
The yoke design and fitting method is the same for all three models; the yoke assemblies differ
only in size.
The assembly comes in three parts – the yoke itself, and two side bars which are bolted to
the enclosure ends. If the yoke assembly is being fitted to a wall or ceiling as a permanent
installation, first and second fix procedures may be adopted as described below. If the cabinet
is to be hung in horizontal orientation from a pole with a scaf clamp, the yoke assembly can be
fitted to the cabinet in a single operation.
Installation:
Yokes may either be permanently fixed to a wall or ceiling, or fitted with a clamp for suspension
from a scaf pole. The yokes are designed for use with cabinets in landscape orientation only;
they do NOT support portrait orientation.
For permanent installations, a first fix/second fix method may be adopted; here the yoke loop is
fixed in position and the cabinet mated to the loop at a later date, after being fitted with the rest
of the yoke assembly.
When suspending the cabinet from a scaf pole, the whole yoke assembly should be fitted to the
cabinet and the cabinet hung as a single exercise. In this case, the “First fix” section of the
Installation instructions below may be ignored.
The components of the yoke assembly are shown below:
First fix:
Yokes may be permanently attached to a wall or ceiling. The yoke allows vertical adjustment and
if mounted using the single attachment point in the centre of the yoke horizontal adjustment
could also be possible.