MT84G User’s Manual V0.1
___________________________________________________________________________________
25
3.3 Continuous Mode
In continuous mode, MT84G keeps scanning barcodes continuously. By
default, after a successful scan, MT84G enters a Scan Interval of 1000ms.
During scanning, keeping the trigger pin low for 50ms will cause the scanning
to pause. Likewise, during pause, keeping the trigger pin low for 50ms will
restart the scanning.
Continuous Mode*
3.3.1 Trigger Control
Scanning below configuration barcodes will allow/prohibit trigger control over
pause/restart scanning in continuous mode.
Trigger Control On*
Trigger Control Off
3.3.2 LED Timeout
Please refer to
3.1.2 LED Timeout
for configuration barcodes.
3.3.3 Scan Interval
Scan interval is the period of time between two consecutive scans. The
configurable range is from 0 to 25500ms; default is 1000ms.
None
