Marley HT1502SSNW Instruction Manual Download

Page: 1 / 20

HTSS Series

Smart Series™ Wall Heater

WHEN USING ELECTRIC APPLIANCES, BASIC PRECAU-
TIONS SHOULD ALWAYS BE FOLLOWED TO REDUCE THE
RISK OF FIRE, ELECTRIC SHOCK, AND INJURY TO PER-
SONS, INCLUDING THE FOLLOWING:

READ ALL INSTRUCTIONS before installing or using the
heater.

ELECTRICAL SHOCK HAZARD:

Disconnect all electrical

power  coming  to  heater  at  circuit  breaker  box  or  main
disconnect switch and lock in OFF position before wiring.  All
wiring  must  be  in  accordance  with The  National  Electrical
Code  and  applicable  local  codes  and  ordinances.
The  heater  must  be  properly  connected  to  an  effective
building ground.

3. Verify the supply voltage coming to heater is the same as

shown on the heater nameplate before energizing.
Energizing at a voltage in excess of nameplate voltage will
damage heater and void warranty.

4. This heater has hot and arcing or sparking parts inside.

Do not install or use in areas where gasoline, paint, or flam-
mable liquids are used or stored.

5. Do not install this heater upside down, sideways, in ceiling,

or floor. Install only as shown in this manual. Refer to

Mounting Clearances

, page 2 for minimum clearances that

must be maintained.

6. The heater assembly must be installed in the back box pro-

vided. Do not operate the heater without the grille installed.

7. This heater is not approved for use in corrosive

atmospheres such as marine, green house or chemical

storage areas.

8. Do not use outdoors.

9. Extreme caution is necessary when any heater is used by or

near children or invalids and whenever the heater is left
operating or unattended.

10. This heater is hot when in use. To avoid burns, do not let

bare skin touch hot surfaces.  Keep combustible materials,
such  as  furniture,  pillows,  bedding,  papers,  clothes,  and
curtains  away  from  heater.    Do  not  block  air  intakes  or
exhaust in any manner.  For efficient and safe operation, we
recommend  keeping  all  items  at  least  3  feet  from  front  of
heater.

11. Do not insert or allow foreign objects to enter any ventilation

or exhaust opening as this may cause an electric shock or
fire, or damage the heater.

12. Should the heater become blocked or otherwise overheat, it

is  provided  with  a  manual-reset  thermal  safety  switch  and
alarm  light  that  will  activate  to  alert  that  the  heater  has
cycled off.  If warning light is on, check to see if the reason
for  the  overheating  can  be  identified.    Remove  any
blockage,  allow  heater  to  cool,  then  press  Reset  button.
Heater should return to normal operation.  Do not continue
to  use  heater  if  it  repeatedly  cycles  off.    Have  it  inspected
and repaired by a qualified repair person.

11. Use this heater only as described in this manual. Any other

use not recommended by the manufacturer may cause fire,
electric shock, or injury to persons.

SAVE THESE INSTRUCTIONS

IMPORTANT INSTRUCTIONS

WARNING

Specifications

MODEL

GRILLE

WIRE

NUMBER

COLOR

VOLTS