12 - Installation manual - Eletta
®
3.2.5 Telescoping shafts installation
In order to adapt to all types of tipping trailers, semi-trailers or roll-off bodies, the Eletta
®
cover is equipped with two
telescoping drive shafts that greatly reduce installation time.
Each shaft can be extended by 300 mm. This makes it possible to cover bodies having a width of 2100 to 2700 mm, without
any further intervention by the installer.
•
Mount the first shaft coupling the joint of its
fixed end to the output shaft of the reducer.
•
Lock the coupling with the hex screws and
the self-locking nut supplied.
•
Extend the shaft.
•
Attach the other end to the lateral drive unit
using the pin supplied.
•
Mount the other telescoping shaft following
the same procedure.
FIXED END
Final result of the
operation