C
C
h
h
a
a
p
p
t
t
e
e
r
r
1
1
I
NTRODUCTION AND INFORMATIONS
1.1 Introduction
Load securing, for example of aggregates, during the freight transport on road is required by law.
Marcolin Covering s.r.l. has developed the Ecotype
Covering System, which fulfils the legal obligation and satisfies practical
and functional needs of its user.
This manual provides all the necessary instructions for a safe application and for keeping fully functional the Ecotype
Covering System.
Thank you for having chosen the Ecotype
Covering System of Marcolin Covering s.r.l.!
1.2 Explanatory convention
When equipped with the electric device with remote contr
ol “TX MARCOLIN”, the covering changes to a “machine” being
moved by a different energy than the human force. For exposition convenience, all along this manual the synonym
“machine” refers to the Ecotype Covering System.
1.3 Information on the use of the machine
The machine was built for operating in environmental temperatures between
– 10° C
and
+ 40° C.
For any other climatic
condition, ask the manufacturer for instructions. The machine’s operational function is confined to cover the tipper body to
prevent material from falling out during road travel.
The covering equipped with electric driving system has to be powered up only when the vehicle is stationary.
1.3.1 Restrictions of use on the Control Box
WARNING!
It is absolutely forbidden to use the Control Box when the vehicle is moving.
The constructor declines any responsibility.
Any other use is defined as “
IMPROPER USE
”. The machine’s “lifecycle” depends on the frequency of its use and the
preservation status in which it is maintained.
1.4 Product warranty
The covering is supplied according to the contractual warranty conditions stipulated at the time of purchase. The warranty
consists in supplying and replacement of components that cannot be
used because of an ascertained material’s flaw and the
repairing of those pieces that are defective: the examination of the defects and their causes it is exclusively carried out by
the manufacturer.
The component’s replacement is made by using exclusively original spare parts.
Any delays do not give the buyer the right to claim for damages, nor to extend the warranty. The warranty ceases if the
machine is used in a manner not conform to these conditions or to the manufacturer’s instructions and if parts are
disassembled, repaired or replaced without the manufacturer’s authorisation.
The manufacturer is exempt from all responsibility and obligation for any accident or damage to people, objects, animals and
environment which could occur for or during the use of the vehicle supplied for installation, that is, also during testing and
even if the accident was caused by a fault in building or materials.
1.5
Declaration of Conformity and Manufacturer’s CE Mark
In compliance with the Machinery Directive 2006/42/EC, which, in Annexes IIA and III, contemplates the declaration of
conformity and the CE marking of the machine, here follows the facsimiles of the EC Declaration of Conformity and the CE
marking plate attached to the machine.
The Declaration of Conformity signed by the legal representative of the MARCOLIN COVERING s.r.l. is handed over
conjointly with the machine.
